INSTALLATION

The EPS ® parking sensor has an easy 3-wire installation and comes complete with Universal Installation Instructions enabling any good DIYer to install this without any problems making the installation simple, safe and secure.

• The EPS ® parking sensor (EPS-DUAL model) consists of the following parts:

	+		+
CENTRA UNIT + CABLE		ANTENNA SENSOR		BUZZER

The model EPS-WBD has the buzzer incorporated into the wave-band display:

DISPLAY

• Application of antenna sensor:

We must first remove the bumper in order to apply the metal strip provided in the kit (it is like an adhesive tape) along the inner surface of the bumper itself.

It is possible to apply the antenna sensor even within bumper affected by some irregularities, as in the example photo. The tape can be bent and curved to follow the shape of the bumper.

• Electrical connections and positioning the central unit:

After the application of the antenna sensor you must make the electrical connections of the central unit. Connect the positive and negative EPS sensor wiring to the positive and negative of the back gear lamp. In this way the system is activated only when the reverse is engaged.

The electronic unit is very small and you can easily place it inside the trunk (most models). In the picture below it is stcked directly on the bumper surface (only EPS-DUAL or EPS-DUAL WBD model).

• Positioning Buzzer/Display:

Finally you can place inside the car cabin the small loudspeaker (EPS-DUAL model) or display (EPS-DUAL WBD model) depending on the model you have chosen.

Positioning the Buzzer		Positioning the Display