EPS-FRONT 4.0 with Display front parking sensor kit
The EPS-FRONT 4.0 with Display is activate by pressing the included push-button switch that mounts discretely in the area under your steering wheel for easy access. It is designed to facilitate the manoeuvres when advancing against an obstacle (car, wall, walking step etc.).
The main feature of this new version is the special connection between the control unit and the antenna sensor which is constituted by a small electronic module.
This allows a more secure assembly by eliminating the possibility of malfunction due to incorrect installation.
The approaching of the obstacle is signalled with Bips with increasing frequency and visual LED's (3 zones) alerting you of your proximity to surrounding objects.
The control unit can be positioned in the cabin under the dshboard on driver's side while the speaker (buzzer) it is easily applicable under the dashboard itself.Find out the price
Lighting on of Leds without sound signal (alert signal).
EPS alerts you of presence and approach of the obstacles.
Bips with increasing frequency (alarm signal).
L'EPS informs that the obstacles is at a distance variable between 30 and 15 cm from the bumper.
YELLOW LED + word AL
Continuous sound low-frequency (risk of contact).
The bumper is 15-10 cm close the obstacle.
RED LED + word ST
Adjustable sensitivity. With the new rear parking sensor EPS-DUAL 3.0 you can choose between four different calibrations; this to facilitate installation on most cars.
Antenna sensor 3.50 meters long: With a longer antenna sensor you can install the EPS-FRONT 4.0 even on very long car bumpers like campers and motor home. Can be cut to the length of the bumper.
The system is activated by pressing the button with bright led and three red dots to confirm activation light up on the display. To deactivate it, just press the button again, otherwise the system will turn off automatically after 2 minutes.
It is not recommended to keep the system active while driving.
On some cars the ideal application area for applying the antenna sensor is at the license plate. Passing the sensor behind the license plate does not affect the obstacle detection ability in the least.
The license plate is not signaled.
The display is activated automatically when reverse gear is engaged, the signalling is done through the illumination of the LEDs and a series of "Beeps" increasing with decreasing distance from any obstacles (people, walls, poles or curbstones, other vehicles).
1) The first two green LEDs inform the driver that an obstacle is approaching.
2) Intermittent sound at a frequency of increasing repetition rate simultaneously with 3 LED color yellow and the word AL (ALARM) in the center of the display when the obstacle comes close to the bumper at a distance between 15 and 30 cm.
3) Switching on of the first red led, followed by the second one with a continuous sound, simultaneously to the word St (STOP) when an obstacle is very close to the bumper (10-15 cm).
Width = 3,5 cm
Length = 6,0 cm
Height = 1,5 cm
Voltage range: 9,5V to 18V
Maximum current consumption: 70 mA
Operating temperature:: -20 to +90 °C
Length = 1 m
Length = 120 cm
12V white LED
Length = 2,50 m
Shielded cable for your connection Central Unit-antenna sensor
Cable: 6 m
Voltage range: 12V
Cable connection with the control unit
Depth: 2,5 cm
Sound: On/Off switch
Length = 3,5 m (Can be cut to the length of the bumper)
Width= 1 cm
Thickness = 0,07 mm
Antenna sensor to be applied inside the bumper
Length = 12 cm
Width = 2,5 cm
Thickness = 3 mm
Adhesive mastic for fixing the ends of the antenna sensor
Please contact us if you have any doubts about the compatibility of your vehicle.
Vehicles not compatible with the parking sensor EPS-FRONT 4.0:
Jeep Wrangler | BMW Z4 (2007) | Fiat Ducato | Land Rover Defender