EPS-FRONT 4.0 front parking sensor kit
The EPS-FRONT 4.0 is activate by pressing the included push-button switch that mounts discretely in the area under your steering wheel for easy access. It is designed to facilitate the manoeuvres when advancing against an obstacle (car, wall, walking step etc.).
The approaching of the obstacle is signalled with three different sounds: alert signal, alarm and risk of contact..
The control unit can be positioned in the cabin under the dshboard on driver's side while the speaker (buzzer) it is easily applicable under the dashboard itself.Find out the price
Bips with increasing frequency (alert signal) EPS alerts you of presence and approach of the obstacles, 60/70 cm.
Intermittent sound at a medium frequency (alarm).
EPS informs that the obstacles is at a distance variable between 30 and 15 cm from the bumper.
Continuous sound low-frequency (risk of contact).
The bumper is 15-10 cm close the obstacle.
Adjustable sensitivity. With the new rear parking sensor EPS-DUAL 3.0 you can choose between four different calibrations; this to facilitate installation on most cars.
Antenna sensor 3.50 meters long: With a longer antenna sensor you can install the EPS-FRONT 4.0 even on very long car bumpers like campers and motor home. Can be cut to the length of the bumper.
The system is activated by pressing the button with bright led and the buzzer emits a "beep" to confirm activation. To deactivate it, just press the button again, otherwise the system will turn off automatically after 2 minutes.
It is not recommended to keep the system active while driving.
On some cars the ideal application area for applying the antenna sensor is at the license plate. Passing the sensor behind the license plate does not affect the obstacle detection ability in the least.
The license plate is not signaled.
Width = 3,5 cm
Length = 6,0 cm
Height = 1,5 cm
Voltage range: 9,5V to 18V
Maximum current consumption: 70 mA
Operating temperature:: -20 to +90 °C
Length = 1 m
Length = 120 cm
12V white LED
Length = 2,50 m
Shielded cable for your connection Central Unit-antenna sensor
Cable: 1,7 m
Length: 5,3 cm
Length = 3,5 m (Can be cut to the length of the bumper)
Width= 1 cm
Thickness = 0,07 mm
Antenna sensor to be applied inside the bumper
Length = 12 cm
Width = 2,5 cm
Thickness = 3 mm
Adhesive mastic for fixing the ends of the antenna sensor
Please contact us if you have any doubts about the compatibility of your vehicle.
Vehicles not compatible with the parking sensor EPS-FRONT 4.0:
Jeep Wrangler | BMW Z4 (2007) | Fiat Ducato | Land Rover Defender